![]() STP and MST (Catalyst 6500/6000 Switches that run Cisco IOS® Software)Ĭonfiguring STP and MST (Catalyst 4500/4000 Switches that run Cisco IOS Software) Refer to these documents for information on the configuration of STP on other switch platforms: If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. Components UsedĪlthough this document uses Cisco Catalyst 5500/5000 Switches, the spanning tree principles that the document presents are applicable to almost all devices that support STP.Ī console cable that is suitable for the Supervisor Engine in the switch There are no specific requirements for this document. The main purpose of STP is to ensure that you do not create loops when you have redundant paths in your network. The specification for STP is IEEE 802.1D. ![]() Spanning Tree Protocol (STP) is a Layer 2 protocol that runs on bridges and switches. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |